Instruction Manual

AFTER SALES SUPPORT 0345 605 2070 25
TROUBLESHOOTING
TROUBLESHOOTING
Suspected malfunctions are often due to causes that the users can x themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
Problem Possible cause Solution
Product does not start
- Not connectted to power
supply
- Power cord or plug
defective
- Other electrical defect to
the product
- Lock-off button not press
- Connect to power supply
- Check by a specilist
electrician
- Check by a specilist
electrician
- Press lock-off button
rst,then the start/stop lever.
Product does not reach
full power
- Power source(e.g.
generator)has to low
voltage.
- Air vents blocked
- Connect to another power
source
- Clean the air vents
Power result
- Cutting device is dull/
damaged
- Scaried material
exceeds capacity
- Scarifying depth is
incorrect
- Replace a new one
- Only scarify materials
according to capacity of the
product
- Adjust depth
WARNING! Only perform thee steps described within these instruction s! All further
inspection, maintenance and repair work must be performed by an authorized service
centre or a similarly qualied specialist if you cannot solve the problem yourself!