Instruction Manual

23 AFTER SALES SUPPORT 0345 605 2067
OPERATION
NOTE: Only operate the product during reasonable hours
– not early in the morning, late at night or on weekends/
public holidays when people might be disturbed. Please
check local restrictions.
Trimming
i. Cut and remove branches exceeding the cutting capacity
of this product using a proper pruner before operation.
ii. Move the cutting device lightly through the surface to
be cut in a sweeping motion following the shape of the
hedge or shrub.
iii. A slight tilt downwards of the cutting device in the
direction of motion is recommended for optimum cutting
performance.
iv. Do not to rush and do not attempt to cut too much with
one stroke of the cutting device.
v. First cut both sides from the bottom cutting upwards to
the top. This will prevent any of the trimmings falling into
the path of the area still to be cut.
vi. After cutting the sides proceed to the top. Try to keep
the cutting device angled at approximately 15° to the
cutting surface.
15°