Instruction Manual

17
AFTER SALES SUPPORT 0345 605 2069
PREPARE
2
INSTALL OR REMOVE BATTERY PACK (See Fig.D1, D2)
After recharging, insert the battery pack into trimmer’s battery port
(Fig.D1). A simple push and slight pressure will be sufficient.
Depress the battery pack release button to release battery pack
from your trimmer (Fig.D2).
NOTE: When removing the battery pack, hold it firmly to avoid
potential accidents.
CHARGING INDICATOR
Light ON/OFF flash Status
Red on
Charging
Red flash
Defective Battery
Green on
Fully Charged
Green flash
Battery Hot/Cold Delay
NOTE:
If the battery pack is locked in the charger, press the battery pack release
button and remove it.
WARNING! When battery charge runs out after continuous use or
exposure to direct sunlight or heat, allow time for the battery to cool down
before re-charging to achieve the full charge.
D1
Release
button
C1
C2
C3
f g
BEFORE PUT INTO OPERATION
CHARGING THE BATTERY PACK (See Fig. C1, C2, C3)
WARNING! The charger and battery pack are specially designed
to work together so do not attempt to use any other devices. Never
insert or allow metallic objects into your charger or battery pack
connections because of an electrical failure and hazard will occur.
NOTE:
a) Do not use any charger other than that specifically provided
for use with the equipment.
b) If the battery pack is very hot you must remove your battery
pack from the charger and allow time for the battery to cool
down before recharging.
c) The battery in your new tool is not charged when it leaves the
plant. Therefore it must be full charged before using the first time.
d) Please charge the battery to reach full or no less than half
charge before storage. If the tool will not be used for long
periods of time, charge the battery every 3-6 months.
CHARGING PROCEDURE
Connect the battery charger to the power supply, the green
light will turn on. Slide the battery pack into the charger to make
the connections(See Fig. C1). The green light will turn off, at
the same time , the red light will turn on to show charging has
started. When charging is completed, the red light will turn off
and the green light will turn on.
After fully charged, unplug the charger and remove the battery
pack for using. (See Fig. C2)
1
D2