Instruction Manual

18
AFTER SALES SUPPORT 0345 605 2069
BEFORE STARTING YOUR POLE HEDGE TRIMMER
Remove the blade sheath as shown in Fig. E.
START OR STOP YOUR HEDGE TRIMMER (See Fig F)
Your trimmer is equipped with a lock-off switch.
Push the Lock-off button backwards; at the same time, press the
on/off switch to start you trimmer.
Release the on/off switch to stop your trimmer.
ADJUSTING THE POLE LENGTH (See Fig G)
To extend the pole, loosen the clamp knob (5) by turning a
nti-clockwise. Then the pole will slide freely.
To lock the pole to the required length, tighten the clamp knob (5)
by turning clockwise.
OPERATION
E
F
Lock-off
switch
On/off
switch
G
Loosen Tighten
Clamp knob
ADJUSTING THE MACHINE HEAD TO THE REQUIRED ANGLE (See Fig H)
Push the lock button of the machine head and then rotate the
machine head to the desired position.
Release the lock button again and check whether the button is
locked in place. (See Fig. H)
NOTE: The Machine head can be locked on 5 positions. (-30°, 0°, 30°,
60°, 90°) (See Fig. H)
H
-30°
0°
30°
60°
90°
Lock button