Instruction Manual

24 25AFTER SALES SUPPORT 0345 605 2067 AFTER SALES SUPPORT 0345 605 2067

ASSEMBLY

i. Connect the battery pack to the battery charger.

ii. Insert the mains plug into the socket. The green charging status LED light will ﬂash. Once the

battery pack is completely charged, the green charging status LED is lit continuously, indicating

that the charging process is complete.

iii. Disconnect the charger from the mains and remove the battery pack from the charger.

iv. Attach the battery pack back to the product.

Charging status LEDs

RED LED turn on Charger ready

green LED ash Battery pack charging

Green LED continuously lit Battery pack fully charged

Red and green LEDs ashing Battery pack defect

Red and green LEDs continuously lit Battery pack too cold or warm

OPERATION

STARTING THE CHAINSAW

Installing the battery pack

i. Keep the battery pack in line with the holder on the device.

ii. Push it forward until it reaches the bottom. Before starting，

make sure the battery pack is ﬁrmly locked in place.

Removing the battery from the product

i. Press the battery pack release button (A) downward.

ii. Pull the battery pack towards the operator, then remove it.

red LED

green LED