SPECIAL PROJECTS Group.
FCC STATEMENT This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Ansr Audio, Inc. could void the user’s authority to operate this equipment. NOTICE There are no user serviceable parts inside.
Contents Safety and environment 4 Introduction 4 Packaging and taking delivery 5 Illustration and indentification 6 Setup and operation 7 Aqua808 and H2O Group.
Safety and Environment * While the Aqua808 transmitter and the H2O headset are waterproof, the Group.X audio unit is not. The Group.X audio unit cannot be used in the water. Becareful not to spill any liquids on the Group.X audio unit. * This equipment may be opened, serviced or repaired by authorized personnel only. There are no user serviceable parts inside. Attempting to open either the Group.X audio unit or the Aqua808 transmitter will void the warranty.
Packaging and Taking Delivery Locate all included components: * The Group.X audio unit and AC / charging adaptor * External antenna * Aqua808 bodypack transmitter and charging cable * H2O headworn microphone and cable All components should be inspected prior to use. Any physical damage should be noted at this time. All shipping materials should be saved and stored in the event your unit should need to be returned for warranty service.
Illustration and Identification 1. Wireless microphone volume 2. Aux input volume 3. Treble tone control 4. Aux input and output 5. Speaker output - SpeakOn type 6. Bass tone control 7. Echo level control 8. DC 8A fuse access 9. Charge / power connect 10. Wired mic combo jack - accepts XLR or ¼ inch input 11. CD volume 12. Wired mic volume 13. Master volume - once mic and music levels are set, use this for overall changes 14. Main power on/off 15. Wireless receiver power LED indicator 16.
Setup and Operation Aqua808 Transmitter and H2O Headworn Microphone Prior to use, the internal battery should charge for a minimum of 12 hours. The battery charging unit is provided with a metal connector identical to the metal connector on the headset cable. To attach, align the notch in the connector inner ring with the alignment pin in the transmitter connector. Once aligned, press together and twist the locking ring to the right until it clicks into place.
Aqua808 Transmitter and H2O Headworn Microphone (continued) A. Headset cable must be attached securely before use in order to be waterproof. B. The slot in the inner ring of the headset cable connector must align with the key in the bodypack transmitter connector. C. Once the headset cable connector is mated to the bodypack transmitter connector, twist the locking collar clockwise to lock in place.
Group.X Audio System Prior to power on, install the included external antenna and set all volumes and echo to minimum, treble and bass to 5. Power on the Group.X main unit and adjust the Master Volume to 2 or 3. This level is simply to allow for adjustment of CD and mic levels - once the CD and mic levels are satisfactory, the Master Volume can be used to adjust the ‘overall’ volume, allowing the preferred mix of CD to mic to remain unchanged. Adjust the CD volume to approximately 5, or or as desired.
CD Player 1. 2. 3. 4. 5. CD insert CD eject Folder up/down Stop Play/pause 6. 7. 8. 9. USB input jack USB input select CD select Track up/down Upon power-up, ANSR AUDIO, INC / SPECIAL PROJECTS will be displayed. A CD may be inserted at this point. Press and release the TRACK arrows to skip ahead or back by track. Press and hold (approximately 2 seconds) the TRACK arrows to fast-forward or reverse within a track. Press and release the FOLDER arrows will also skip ahead or back by track.
Charging the Group.X Audio System The Group.X Aqua is powered by two 12 Volt DC, 3.5 amp-hour batteries, yielding an average 6 - 8 hours of operation, depending on useage. Prior to battery operation, allow the batteries to charge for 10 hours with the main power off. The Group.X Aqua features an active battery monitor to check battery status at a glance. As battery power is depleted, remaining power will be indicated in the RECHARGEABLE BATTERY LEVEL METER.
General Maintenance and Cleaning While the H2O microphone and Aqua808 transmitter are waterproof, the Group. X audio unit is not. As such, care should be taken to avoid exposure to dust and moisture. High humidity can damage this equipment. Do not store your Group.X audio unit poolside. A damp, non-abrasive cloth is all that is needed to clean the outer case of the Group.X audio unit. Do not use abrasive cleaners or oils.
Specifications Group.X Audio Unit Power Output 70W RMS 100W Peak (2) 12V, 7 AH Approx. 6-7 hours Batteries Operating time Inputs/Sources Internal wireless microphone receiver AUX External microphone Internal CD player MP3 Speakers Stereo RCA XLR combo USB 8” Full range 2.5 “ Tweeter 17 x 11 x 9.5 in. 32 lbs. Dimensions (HxWxD) Weight Aqua808 and H2O Operating Frequency Transmitter Power Battery Generating Element Polar Pattern Frequency Response Maximum Input SPL ��������������� VHF, 200-204.
Ansr Audio, Inc., Special Projects 3800 HWY 271 North Powderly, Texas 75473 866-491-2677 www.ansraudio.com Copyright ©2008, Ansr Audio, Inc.
