User Manual

24. Power Supply Connector
If required, the VU meters may be calibrated to indicate -10dbV.
An AC voltmeter and signal generator will be required to perform this
adjustment.
This multipin connector may be used to interface the XTRAMIXcxi -01
expander.
Adding the XTRAMIXcxi -01 expander will increase the capacity of
your system to 96 inputs and 8 outputs. Certain master functions are
disabled on the XTRAMIXcxi -01 expander in order that all subgroup,
effects, and stereo program busses are shared with the Xtramix master
unit.
A special interface cable is supplied with the XTRAMIXcxi -01
expander at an additional cost.
Contact Speck Electronics for details on ordering this expander or
converting your existing Xtramix to an expander.
For the pin assignment configuration and installation instructions, refer
to the Installation Section in Chapter 3 of this manual.
This 4 pin connector will accommodate the connector from the power
supply cable. The connectors are keyed so they will only fit in one
direction. For installation instructions refer to the Installation Section in
Chapter 3 of this manual.
43
23. Expander Connector
Chapter 4 Operation Section