DVR User Manual

Operation Instruction

Highlighting the box under the Interval heading beside each alarm-in and pressing the button

allows you to change the interval that you want the DVR to run self-diagnostics on Alarm Inputs.

You can select from 1 hr. to 30 days or Never.

Highlight the Storage tab and the Storage setup screen displays.

Highlight the first box beside Disk Temperature, and press the

button. Use the Up and Down

arrow buttons to scroll through the numbers. Refer to the hard disk drive manufacturer’s

documentation for the correct temperature setting. If the temperature of hard disk drive exceeds

the defined threshold, the system triggers an alert.

Figure 40 ─ Health Check setup screen.

The DVR can be configured to run self-

diagnostics and report the results.

Highlighting the box beside System and

pressing the

button allows you to select the

interval that you want the DVR to run self-

diagnostics on the system. You can select from

1 hr. to 30 days or Never.

Highlight the Setup... box beside Check Recording and

press the

button. The Check Recording screen appears.

Highlighting Schedule On and pressing the button

toggles On and Off. When set to On, you can select the day,

time range and interval that you want the DVR to run self-

diagnostics on the recorder. The Interval can be selectable

from 1 min. to 7 days or Never. The

box allows you to

delete a check recording schedule.

Figure 41 ─ Storage setup screen.

Highlight the box beside Disk Bad Notify, and

press the

button. Select percentage level of

bad disk sectors at which you want the DVR to

trigger an alert. Percentage levels range from

10% to 90%.

Highlight the box beside Disk Almost Full

Notify, and press the

button. Select the

percentage level of disk usage at which you want

the DVR to trigger an alert. Percentage levels

range from 80% to 99%.