Manual

14/56
Installation with Ceiling Mount Bracket (Ver. 2.0)
①
Remove the ceiling tile from the
ceiling and cut a hole whose diameter
is 30~40mm on the ceiling tile to pass
the wire(s) and cable(s) through to the
upside of the ceiling. (In case of the
wiring and cabling through the
mounting surface only) Then prepare
the ceiling mount bracket. Pull the
wire(s) for the system as below.
(Anchor Bolt 3/8"
×70)
②
Hook up
“
Drop Prevention Spring
”
on main body to prevent camera from
unexpected drop and pull the wire(s)
and cable(s) for the system as below.
Spr ing Wi re Hoo k
③
L
ine up the mold lines and assemble
main body to mount adaptor and turn
it. And assemble the main body with
the camera mount adaptor with the 3
screws. ( TORX SCREW M4×18 ).
END
START
④
Screw the dome cover to the main
body and remove the protection vinyl
from the dome cover.
Important Notice
 Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
 To adjust the installation height from the mounting surface, the pipe and coupler should be needed between
the surface mount part of the ceiling mount bracket and the camera mount part of the ceiling mount bracket.
Note that they are not supplied by the manufacturer.
I
NSTALLATION
2
** Attention **
If you use the old
ceiling mount bracket,
please use the new
mounting adaptor
from the camera
package.