Manual

15/56
Installation with Wall Mount Bracket
①
Make a hole whose diameter is
30~40mm on the mounting surface to
pass the wire(s) and cable(s) through
the mounting surface. (In case of the
wiring and cabling through the
mounting surface only) Then prepare
the wall mount bracket. Pull the
wire(s) and cable(s) for the system as
below. Attach the wall mount bracket
to the mounting surface. (Hex Lag
#14
×50)
②
Hook up
“
Drop Prevention Spring
”
on main body to prevent camera from
unexpected drop and pull the wire(s)
and cable(s) for the system as below.
Spr ing Wi re Hoo k
③
Line up the mold lines and assemble
main body to mount adaptor and turn
it. And assemble the main body with
the camera mount adaptor with the 3
screws. ( TORX SCREW M4×18 ).
END
START
④
Screw the dome cover to the main
body and remove the protection vinyl
from the dome cover.
Important Notice
 Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
INSTALLATION
2
** Attention **
If you use the old wall
mount bracket, please
use the new mounting
adaptor from the
camera package.