Manual

31/56
Camera Setup
ZOOM CAMERA SETUP
------------------------
FOCUS MODE SEMIAUTO
DIGITAL ZOOM ON
FLICKERLESS OFF
COLOR ON
IMAGE FLIP OFF
<WHITE BALANCE SETUP>
<AUTO EXPOSURE SETUP>
<SPECIAL>
BACK
EXIT
OSD MENU
4
Sets the general functions of zoom camera module.
 Focus Mode [AUTO/MANUAL/SEMIAUTO]
Sets camera Focus mode.
 SEMIAUTO Mode
This mode automatically exchanges focus
modes between Manual Focus mode and
Auto Focus mode by operation. Manual
Focus mode activates in preset operation
and Auto Focus mode activates during jog
operation. With Manual mode at presets,
Focus data is memorized in each preset in
advance and the camera calls focus data in
correspondence with presets as soon as
camera arrives at presets. It should shorten
time to get focuses. Focus mode
automatically changes to Auto Focus mode
when jog operation starts.
 Digital Zoom [ON/OFF]
Sets the digital zoom functions to ON/OFF.
If this is set to OFF, the optical zoom
function runs but the zoom function stops
at the end of optical zoom magnification.
 Flickerless [ON/OFF]
If NTSC camera is used in 50Hz frequency
circumstance or if PAL camera is used in
60Hz frequency circumstance, there should
be flicker on monitor since power
frequency is different from sync frequency
of camera. In this case, set it to ON to
prevent flicker
 Color [ON/OFF]
 Image Flip [ON/OFF]
Sets System Image Flip Function to ON/OFF.
When this function is set to ON, flipped
images always come out. When the camera
is installed as Desktop type, set to ON to
get proper images.