User's Manual

Camera Management
NVR User Manual
16
The IP cameras with PoE function which directly connect to the PoE port of the NVR will be displayed automatically in the camera list. Refer to the
picture below. The IP camera which occupies the PoE resource has a prefix shown before its camera name. The prefix consists of PoE plus PoE port
number. The IP camera which connects to the PoE port cannot be deleted from the camera list manually.
 The IP camera which directly connects to the PoE port of the NVR through private protocol will be shown automatically in the camera list.
 One of the two conditions must be met if the IP camera which directly connects to the PoE port of the NVR through ONVIF protocol should be
shown automatically in the camera list.
 The IP camera which directly connects to the PoE port is in the same network segment with the internal Ethernet port.
 The DHCP (obtain an IP address automatically) of the IP camera which directly connects to the PoE port is enabled.
If the IP camera which connects to the PoE port cannot be displayed automatically in the camera list, please refer to Q6 in Appendix A FAQ for details.
4.2 Add/Edit Camera Group
4.2.1 Add Camera Group
Click “Edit Camera Group” in the above interface to go to the interface as shown below.
Click to pop up the window as shown below. Set the group name and dwell time (the dwell time of the camera group sequence view) in the
window. Check the cameras and then click “Add” to add group. Click to view the cameras in the group after adding group.
4.2.2 Edit Camera Group