User's Manual

Camera Management
NVR User Manual
19
Ø Add Manually
Enter the IP address or domain name (click in the IP address column to pop up the domain name input window, enter the domain name of the
IPC in the window and then click “OK” button), port, username and password of the camera and then select the protocol. Click “Test” to test the
effectiveness of the input information and then click “Add” button (you can input one camera’s information or above such as IP address, username
and password before clicking “Add” button). Click to delete the camera. Click “Default Password” to set the default username and password
of each camera.
Note: Some models may not support this function.
Click StartàSettingsàSystemàBasicàGeneral Settings to check “Enable Add IPC by Zero Operation”. If the NVR has unoccupied channels, it can
add IPC without any operation by restarting.
Ø Add Recorder
l Quickly Add：Select the searched NVR/DVR and the click “Add” to add NVR in the same local network.