User's Manual

Live View Introduction

NVR User Manual

① Click “Customize Layout” in the above interface

② Click to add a display mode name and then set the screen mode.

③ Add the cameras and adjust the cameras’ display sequence as required.

④ Click under the display mode list.

Method Two:

① Click StartàSettingsàSystemàBasicàOutput Settings to go to the interface and then set the screen mode.

② Double click the camera or camera group in the list to add them to the selected window.

③ Click to save the current display mode (refer to 5.2.4 Scheme View In Sequence for detail configurations). The display mode will be saved

and displayed in the display mode list in the live view interface.

Ø Edit Display Mode

Click “Customize Layout” tab in the live view interface and then select one display mode in the list. Click to edit the display mode name; click

to delete the display mode.

5.2.2 Quick Sequence View

You can start quick sequence view if the scheme has not been created. If the scheme has been created, please refer to 5.2.4 Scheme View in Sequence

for details.

Go to the live view interface and then click to pop up a little window. Set the dwell time in the window and then click to view the live

group by group according to the camera number of the current screen mode. Double click the sequence view interface to pause the view; double

click again to restore the view. Click to stop the view.