User's Manual

Live View Introduction
NVR User Manual
27
Ø Add Scheme
Click in area ① to create a new scheme. Click on the top right corner of the scheme to delete it.
Ø Configure Scheme
a) Select a scheme in area ① and then click the screen mode button on the tool bar to set the screen mode of the scheme.
b) Select a camera window in area ② and then double click the camera or group in area ③. The camera or group will be added into the selected
window. One camera in the same scheme cannot repeat. You can click the right-click menu “Clear” in area ② to remove a single camera or click
to remove all the cameras.
c) Click “Apply” to save the settings.
Ø Start Sequence View
Go to the live view interface and then click to open a window. Set the dwell time in the window and then click to start scheme view in
sequence. Double click the sequence view interface to pause the view; double click again to restore the view. Click to stop the view.
5.3 Image Configuration
5.3.1 OSD Settings
Click StartàSettingsàCameraàImageàOSD Settings to go to the interface as shown below. Select the camera, enter the camera name (or double
click the camera name in the camera list to change the camera name), enable or disable the name and time OSDs (if enabled, drag the red name and
time OSDs directly in the image view area to change the OSDs’ display position) and select the date and time formats. Click “Apply” to save the
settings.