User's Manual

Alarm Management
NVR User Manual
64
Missing object: Alarms will be triggered if there are articles missing in the detection area drew by the users.
③ Select the alarm area. A maximum of 4 alarm areas can be set.
④ Draw the alarm area of the object detection. Refer to the interface as shown above. Check “Draw Area” and then click around the area where
you want to set as the alarm area in the image (the alarm area should be a closed area). Uncheck the “Draw Area” if you finish the drawing. Click the
“Clear” to delete the alarm area.
⑤ Click “Apply” to save the settings.
⑥ Click “Processing Mode” to go to the alarm handling configuration interface of object detection.
Object Detection Alarm Handling Configuration:
① Click StartàSettingsàAlarmàSmart EventàObject Detection to go to the following interface.
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-mail”. The alarm handling setting of object
detection alarm is similar to that of the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click “Apply” to save the settings. You can click “Object Config” to go to the object detection configuration interface.
9.4.7 Tampering
Tampering Configuration:
① Click StartàSettingsàCameraà Smart SettingsàTampering to go to the following interface.