Quick Start Guide Full HD IP Bullet Camera O3VLB3 Version 1.
Welcome Thank you for purchasing this network camera! This owner’s manual is designed to be a reference tool for your system. Please read this manual carefully before operating the unit and retain it for future reference. Should you require any technical assistance, please contact Speco Technologies Technical Support.
Important Safeguards and Warnings 1 ．Electrical safety All installation and operation here should conform to local electrical safety codes. Use a certified/listed 12VDC Class 2 power supply only. Please note: Do not connect two power supplying sources to the device at the same time; it may result in device damage! The product must be grounded to reduce the risk of electric shock. Improper handling and/or installation could run the risk of fire or electrical shock.
Statement This guide is for reference only. Product, manuals and specifications may be modified without prior notice. Speco Technologies reserves the right to modify these without notice and without incurring any obligation. Speco Technologies is not liable for any loss caused by improper operation. Note: Before installation, check the package and make sure that all components are included. Contact your rep or Speco customer service department immediately if something is broken or missing in the package.
Table of Contents 1 Physical Specifications .............................................................................................................. 1 1.1 1.2 2 Device Installation .................................................................................................................... 2 2.1 3 Installation Steps ........................................................................................................ 2 IP Scanner .........................................................
1 Physical Specifications 1.1 Device External Cable You can refer to the following figure for cable information. See Figure 1-1. Figure 1-1 Cable Please refer to the following sheet for detailed information. No. Port name Function description 1 Ethernet port Network data in/out and PoE 2 DC power jack Connect to DC 12V power 1.2 Dimensions Please refer to the following figure for dimension information. The unit is in mm. See Figure1-2.
2 Device Installation Note: Before installation, please make sure the installation surface can support a minimum of 3 times the weight of the camera 2.1 Installation Steps Figure 2-1 Device installation 1 Please see Figure 2-1 and Figure 2-2 Step 1 Dig holes on the installation surface (wall or ceiling). Step 2 Take out the expansion bolts from the accessories bag and insert them into the holes. Step 3 Take out the installation screws. Tighten the screws to fix the device on the surface.
Figure 2-2 Device installation 2 Step 5 Use the screwdriver (in accessories bag) to loosen adjusting screw. Step 6 Adjust the device in all possible directions, and set its monitoring direction according to the requirements. Step 7 Use the screwdriver to tighten the adjusting screws.
3 IP Scanner IP Scanner can search for the device on the local network. Please note that only devices that are on the same subnet can be discovered. 3.1 Operation Open up IP Scanner. Error! Reference source not found. In the device list, you can view the IP address, model number, and MA MAC C address of each device. Select the applicable device and double click to open up the web viewer.
4 Web Operation This device supports viewing and management via a web browser on a PC. 4.1 Login and Main Interface Open the browser and input network camera address in the address bar or double click the device in IP Scanner. See Figure 4- 1. Input your IP address here Figure 4- 1 IP address The login interface is shown as below. See Figure 4- 2. Please input your user name and password. Default user name is admin and password is 1234.
