User's Manual

18
4.3.3 Alarm In (Sensor Input)
This function is only available for some models.To set sensor alarm (alarm in):
Go toEvent SetupAlarm In interface as shown below.
1. Click “Enable” and set the alarm type, alarm holding time and sensor name.
2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to motion detection chapter for details.
3. Click “Save” button to save the settings.
4. Set the schedule of the sensor alarm. The setup steps of the schedule are the same as the schedule recording setup. (See
Schedule Recording).
4.3.4 Alarm Out
This function is only available for some models. Go to AlarmAlarm Out.
Alarm Out Mode: Alarm linkage, manual operation, day/night switch linkage and schedule are optional.
Alarm Linkage: Having selected this mode, select alarm out name, alarm holding time at the “Alarm Holding Time” pull down list
boxand alarm type.
Manual Operation: Having selected this mode, select alarm type and click “Open” to trigger the alarm out immediately; click “Close”
to stop alarm.