Quick Start Guide O4VB1
1 Warning and Caution ■ If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble the camera yourself. Any unauthorized changes or modifications could void the warranty. ■ Do not allow water or liquid intrusion into the camera. ■ All installation and operation here should conform to local electrical safety codes. Make sure the device is firmly installed on the wall or ceiling. ■ Do not use camera beyond specified voltage range.
Camera Quick start guide CD Plastic plug × 4 4 tapping screws Drill Template Junction box Overview 33 Overview 3 4 1 2 5 6 1 Fixed ring 4 DC power connector 2 Mounting base 5 Micro SD card slot 3 Ethernet connector 6 Reset
Se cu rit y Ca p DC12V * 1 It is recommended to install the security cap for outdoor installations. * 2 DC 12V power supply is not required if a PoE switch or injector is used to power the camera. ► Connecting Network Cable 1 2 3 ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through both elements. Then crimp the cable with RJ 45 connector. ③ Connect the cable to the hermetic connector. Then tighten the nut and the main cover.
4 Installation * Before you start, please make sure that the wall or ceiling is strong enough to withstand three times the weight of the camera. ① Open the mounting base and the upper cover of the junction box. Mounting Base Upper Cover ② Install junction box onto the wall by using the screws provided. ③ Fasten the camera onto the mounting base.
④ Connect the cables and then i nstall the camera onto the junction box as shown below. ⑤ Bracket Adjustment-Loosen the fixed ring to adjust the view angle of the camera. After you get the optimum angle of view, tighten the fixed ring to complete the installation.
5 Web Operation and Login IP Scanner can search for the device on the local network. ● Operation ① Make sure that the camera and the PC are connected to the same local network. The camera is set to DHCP by default. ② Install IP Scanner from the CD and run it after installation. O4VB1 ③ In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer.
The login interface is shown above. Default user name is admin and password is 1234. After logging in, follow directions to install applicable plugins.
