Quick Start Guide O8D7M
Welcome Thank you for purchasing this network camera! This owner's manual is designed to be a reference tool for your system. Please read this manual carefully before operating the unit and retain it for future reference. Should you require any technical assistance, contact Speco Technologies Tech Support at 1-800-645-5516 Important Safeguards and Warning 1. Electrical safety All installation and operation here should conform to local electrical safety codes.
dampened with a small quantity of neutral detergent. Finally use the dry cloth to clean the device. Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may result in poor IR functionality and/or IR reflection. The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
Camera Quick start guide 4 tapping screws PA 4×25 Drill template CD Plastic plug ×4 CVBS&DC Screwdriver Junction box IN cables Overview 32 Overview 1 432 ALAR M 1 7 8 11 10 R ES 9 TF ET Ethernet connector 2 1 3 4 5 6 2 MIC input (3.5mm) 3 Line out (3.
43 AL AR 21 M 1--ALM-COM 2--ALM-OPEN 3--ALM-INA 4--ALM-GND DC12V * 1 It is recommended to install the security cap for outdoor installations. * 2 DC 12V power supply is not required if a PoE switch or injector is used to power the camera. ► Connecting Network Cable 1 2 3 ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through both elements. Then crimp the cable with RJ 45 connector. ③ Connect the cable to the hermetic connector.
3 Installation * Before you start, please make sure that the wall or ceiling is strong enough to withstand three times the weight of the camera. ① Open the upper cover of the junction box. Then install junction box onto the wall by using the screws provided. Upper Cover ② Route the cables through the cable hole (take side conduit cabling for example). Then reinstall the upper cover to the junction box.
③ Loosen the screws to open the lower dome and then loosen the lock screw to remove the mounting base. Lock Screw Mounting Base Lower Dome ④ Install the mounting base onto the junction box. Then connect the cables and fix the dome to the mounting base with the lock screw.
⑤Three-axis Adjustment-Before adjustment, preview the image of the camera on a monitor and then adjust the camera according to the figure below to get an optimum angle. Tilt 0°~77° Pan 0°~360° Rotation 0°~360° ⑥ Install the lower dome back to the camera and fix it with the screws. 4 Web Operation and Login IP Scanner can search for the device on the local network. ● Operation ① Make sure that the camera and the PC are connected to the same local network. The camera is set to DHCP by default.
O8D7M 5C:F2:07:24:68:9A ③ In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer. You can also manually enter the IP address in the address bar of the web browser. The login interface is shown above. Default user name is admin and password is 1234. After logging in, follow directions to install applicable plugins.
