VLB5 /VLB6/ VLD5 / VLD6M User Manual Thank you for purchasing our product. Speco Technologies is constantly developing and improving products. We reserve the right to modify product design and specifications without notice and without incurring any obligation.
Warnings ■ If the product does not work properly, please contact the dealer or where the product was purchased. Speco Technologies is not responsible for any problems caused by improper operation or repair. ■ Keep away from liquid while in use. ■ All installation and operation here should conform to local electrical safety codes. ■ Make sure the power supply voltage is correct before using the camera. ■ Do not drop the camera or subject it to physical shock.
● Backlight Compensation (BLC) When the back of the captured object is too much bright, you can set BLC for the captured object to make it clearer. Cables Video Output Video Switch Cable Power Cable Video Switch: Four video output modes can be optional--AHD, TVI, CVI and CVBS (a) remove the cover of the video switch cable; (b) hold and press the button in the video switch cable for 5 seconds to switch the current video output.
2. Route and connect the cables . 3. Secure the mounting base with camera to the wall with screws as shown below. Rubber plug VLB6 VLB5 4. Bracket adjustment. Before adjustment, preview the image of the camera on a monitor and then loosen the fixed ring to adjust the view angle of the camera. Tighten the fixed ring after the adjustment. 5. Focus and zoom adjustment ( If the camera you get is fixed lens, please skip this step).
74.3 90.2mm (mm) ∅4.6 90.2mm 74.3 VLD5 VLD6M 2. Rotate the trim ring anticlockwise to remove it from the camera. Trim ring 3. Loosen the screws to open the lower dome. Then route and connect the cables. 4. Secure the camera to the wall with screws provided as shown below. Rubber plug * Install it when routing the cables through the ceiling.
5. Three-axis adjustment. Before adjustment, preview the image of the camera on a monitor and then adjust the camera according to the figure below to get an optimum angle. Pan 0°~355° Pan 0°~345° Tilt 0°~77° Turn Tilt 0°~67° Rotation 0°~345° Rotation 0°~355° VLD5 VLD6M 6. Install the lower dome back to the camera and fix it with screws. Then put the trim ring onto the lower dome and then rotate it clockwise until it is locked. Finally, remove the protection film softly.
Specifications Models VLB5 Specifications VLB6 VLD5 VLD6M Camera Image Sensor 1/2.9" CM O S Resolution 2MP 1/2.8" CMOS Image size 1920×1080 Video Output AHD/TVI/CVI/CVBS (*camera comes defaulted to HD-TVI) Image System PAL/NTSC Electronic Shutter Auto; 1/50s~1/100000s(PAL);1/60s~1/100000s (NTSC) IR Distance (feet) 65.6~98.4 Frame Rate 30fps(60Hz),25fps(50Hz) Min. Illumination Color:0.001lux@F1.2, AGC ON; B/W: 0lux with IR Lens 2.
Model: VLB5 /VLB6/VLD5/VLD6M Federal Communications Commission (FCC) Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Responsible Party: Speco Technologies 200 New Highway Amityville, NY 11701 www.specotech.
