Quick start Guide

App Installation
2
Speco Connect l WIFIMOD Quick Guide
www.specotech.com
App Installation
3
Speco Connect l WIFIMOD Quick Guide
www.specotech.com
Specification
1
Speco Connect l WIFIMOD Quick Guide
www.specotech.com
Quick Guide
WIFIMOD
WIFI Adaptor
for IP Cameras
Wi-Fi
Wireless RF
Data Rate
Setup Environment
Access method
Wi-Fi Security
Status LED
Wi-Fi Antenna
Factory Default SW
Network Protocol
Wi-Fi
Power
Operating Temperature
Operating Humidity
Dimension (WxHxD)
2T2R, Wi-Fi 2.4G 802.11b/g/n
2.4GHz
802.11b - Maximum 11Mbps X 2
802.11g - Maximum 54Mbps X 2
802.11n - Maximum 150Mbps X 2
AP Search
CSMA / CA
- WEP (40-bit, 128-bit)
- WPA/WPA2 (TKIP,AES)
2EA (Wi-Fi, WPS Status)
SMA Type DiPole
1EA
- IPv4, TCP, UDP, IGMP, ICMP, ARP, RARP, PPPoE, RTCP
- RTP, RTSP, SDP, HTTP,DHCP, UPnP
- NTP, DNS, SOCKS
802.11b/g/n 2.4G 2T2R
- Recommended adapter
IEEE802.3at Type1(af): 0.5A@48V DC
IEEE802.3at Type2(PoE+): 1.0@48V DC
- PSE module is Compliant with IEEE802.3at Type1(af) & Type 2
- PSE function is not supported with 12VDC adapter.
14°F ~ 122°F
8 ~ 80% RH
1.79” x 1” x 3.49”
WIFIMOD MODEL
Wireless
Network
ETC
1. Power Connection
1.1. Plug the 48V or 12V DC adapter to DC-IN jack.
1.2. You can use PSE (power sourcing equipment) function with
the 48V DC adaptor only (1.0A or more is recommended).
1.3. Plug the adapter cord into the power outlet.
1.4. Connect the LAN port to the IP camera with LAN cable.
2. Connect Wi-Fi to AP (using WPS button)
2.1. Press WPS button on the Access Point.
2.2. Press and hold WPS button on the unit for more than
3 seconds. A light on WPS button will change from blinking
to solid when connection is established.
4. Product registration to “Speco Connect” App
4.1. Connect your mobile device to the Access Point via Wi-Fi
before connecting to the camera.
4.2. Open “Speco Connect” app.
3. Install “Speco Connect” App
3.1. Search for the App using Keyword “Speco Connect” or “Speco”
within the app store and install it.
2.3. Wi-Fi LED will turn ON when Wi-Fi is connected to the Access
Point.
2.4. If the Access Point does not support the WPS function,
set the Access Point information using “Speco Connect” app.
3.1.
4.3. When the camera is not registered, “Add Camera” message will
pop-up. Press OK button to add the camera.
The camera can also be added by touching on “+” button at the
upper-right corner.
4.4. Add New Camera.
– When adding a new camera, touch “Next” button in “Add
Camera” window.
4
Android Device
6
6
iOS Device
Caution
1. Please use a DC 12V power adaptor or the DC 48V
power adaptor that's included.
2. Don't change the network configurations of the
camera's setup. Camera's default network mode
should be DHCP.