User Guide

11
2. Initial Boot up Process
2-1. Initial Boot up and Basic Time Setup
1. During the first boot up, the following logo and message will be displayed.
2. After the logo, select the language as specified below.
1) User has to set a password before using.
Can not use ‘1111’ when the initial boot up password set.
But user can set ‘1111’ as a password through [Setup > User Management > Password Setup]
2) DVR will not proceed when user put the password ‘1111’.
(EZ Setup Page Reference, Page 16-17)
2-2. Setting Daylight Saving Time
To enable Daylight Saving feature/NTP synchronization, take the following steps.
1. Enter the Setup mode. The default Username is “admin” and enter a password set on the initial
boot-up process.