User Guide

30
Figure 4.4.1. Device Setup Screen
Table 4.4.1. Menu Items in Device Setup Screen
Item Description
Alarm Out/
Alarm Duration
Set the sensor, motion, and video loss for triggering alarm relay
HDD Error and Video Loss can trigger beeping
.
Digital Deterrent Setup schedule and audio recordings for Digital Deterrent.
Controller & PTZ Set the PTZ baud rate, protocol, and ID.
Spot-Out CVBS Out is can be used as Composite Video Output or Spot-Out
depending on the Sub Monitor Out of Display setup menu.
(Spot-On Event on/off, Spot Event Dwell Time, Sequence On/off, Sequence
Dwell Time, Spot Channel) *The last image will keep on the screen until the
next event occurred.
Site Select specified channel for motion zone setup.
Motion Zone Select either Full Zone or Partial Zone for motion detection.
Press the right button of mouse to exit from Motion Zone grid screen.
Motion Sensitivity Set the motion sensitivity for the selected channel.
Control the motion sensitivity from 1 to 9.
(1 – Lowest sensitivity, 9 – Highest sensitivity)
Key Tone Enable/disable key tone.