User Guide

35
Table 4.4.3. Menu Item in Spot-Out Setup Screen
Item Description
Spot Out Only 1 Spot Out is available to use.
Spot Type Spot 1 supports only Full type. (1 channel only)
Spot On Event Enable/disable channel change if an event occurs on a channel.
Spot Event
Dwell Time
Set the dwell time for the display of the event activated channel.
(3-10 sec)
Sequence Enable/disable sequential display of spot channel in full screen.
If select “on”, the selected channel will be displayed on the monitor
periodically.
Sequence Dwell
Time
Set the dwell time for the spot channel display.(3-10 sec)
Spot Channel Select a channel for spot monitoring using the mouse or the remote
control and press “ok” button.
4-4-4. Motion Zone Setup
Select Motion Zone using the mouse or the remote control and select either Partial Zone or Full Zone using
the mouse control. The default value is Full Zone.
If Full Zone is selected, the motion zone grid screen is not displayed. Only set the level of sensitivity for
Motion Sensitivity.
Full Zone: The motion sensor is active on the whole screen.
Partial Zone: The motion sensor is active in the set detection frame.
Select the motion detection position using the mouse or the remote control. Then left click on the mouse or
left click and drag the mouse pointer to select or deselect the area. Highlighted area indicates the partial
motion detection zone. Press the “ESC” button or right click on the mouse to return to the previous menu.
Figure 4.4.8. Motion Zone Grid Screen