User Manual

EZ Setup & Main Interface
NVR User Manual
9
⑥ Add Camera. Add cameras via PoE first before adding any cameras from the LAN. Speco cameras added via the PoE ports will automatically be
added to the corresponding channel. To add cameras from the LAN, make sure all cameras are set to DHCP. Click “Refresh” to refresh the list of online
IP cameras which are in the same local network with NVR and then click to add the searched camera. Click “Add All” to add all the cameras in
the list. Click to delete the added camera. Click “Delete All” to delete all the added cameras.
Click to edit the searched IP camera as shown on the below left. Enter the new IP address, subnet mask, gateway, username and the password
of the camera. You can check “Sync to IPC” to modify the IP address of the IPC via different network segments for being in the same network segment
with the NVR. Click “OK” to save the settings.
Click to edit the added camera as shown on the above right. Enter the new camera name, IP address, port, username and the password of the
camera. You can click “Test” to test the effectiveness of the input information. Click “OK” to save the settings. You can change the IP camera name
only when the added camera is online. Click “Next” to continue.
⑦ Record Settings. Two record modes are available: auto and manual.
Auto: Select one auto mode in the interface as shown below and then click “Next” button to save the settings. Click “Advanced” to self-define record
mode. See 7.1.1 Mode Configuration for details.