User Manual

AI Event Management
NVR User Manual
59
for details).
⑤ Click “Apply” to save the settings.
9.7 Line Crossing Counting
Only some IPCs may support this function.
 People counting in the pre-defined area:
This function is to calculate the number of people entering or exiting in the detected area on the video by detecting, tracking and counting the head
shapes of people.
Note: Only some specific IPCs may support this function.
① Click StartSettingsAI/EventAI EventLine Crossing Counting to go to the following interface.
② Select the camera, enable the line crossing people counting detection and set the duration, sensitivity, statistic cycle, enter threshold, departure
threshold and retention threshold.
Statistic cycle: Always, daily, weekly and monthly are optional.
Manual Reset: The current number of people counting will be cleared and the statistic cycle will restart by clicking “Manual Reset” button.
③ Set the alarm area and entrance direction. Click “Draw Area” and drag the mouse to draw a rectangle area. Drag the rectangle to change its
position. Uncheck the “Draw Area” if you finish the drawing. Click “Clear” to clear the area. Click and drag the arrow or the other end of the arrow
line to change the people entrance direction.
⑥ Click “Apply” to save the settings.
 Line Crossing People/Vehicle/Non-Vehicle Counting
Only some IPCs support this function. If your camera doesn’t support this function, please skip the following instructions.
① Click StartSettingsAI/EventAI EventLine Crossing Counting to go to the following interface.