User Manual

General Event Management

NVR User Manual

11.3 Combination Alarm

① Click StartSettingsAlarm Combination Alarm to go to the following interface.

② Customize combination alarm. Set alarm name and click “Configure” under the Combined Alarm Configuration item. Then select alarm type and

alarm source. Finally, click “OK” to save the settings.

③ Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-mail”. The alarm handling setting of

combination alarm is similar to that of the sensor alarm (see 11.1 Sensor Alarm for details).

④ Click “Apply” to save the settings.

11.4 IPC Offline Settings

① Click StartSettingsAI/EventIPC Offline Settings to go to the interface as shown below.

② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”, “Pop-up Message Box” and “E-mail”. The IPC Offline

Settings are similar to that of the sensor alarm (see 11.1 Sensor Alarm for details).

③ Click “Apply” to save the settings.

11.5 Exception Alarm Settings

① Click StartSettingsAI/EventException Alarm to go to the interface as shown below.

② Enable or disable “Push”, “Alarm-out”, “Buzzer”, “Pop-up Message Box” and “E-mail”. The exception handling settings are similar to that of the

sensor alarm (see 11.1 Sensor Alarm for details).