User Manual

General Event Management
NVR User Manual
79
③ Click “Apply” to save the settings.
11.6 Alarm Event Notification
11.6.1 Alarm-out
① Click StartSettingsAl/EventEvent Notification to go to the following interface.
② Set the delay time and the schedule of each alarm-out. You can click “Edit Schedules” to edit the schedules (see 7.1.2 Schedule Settings for
details).
③ Click “Apply” to save the settings. You can click “Test” to test the alarm output.
11.6.2 E-mail
Click StartSettingsAI/EventEvent NotificationE-mail to go to the e-mail configuration interface. Set the e-mail address of the recipients. See
13.1.5 E-mail Configuration for details.
11.6.3 Display
Click StartSettingsAI/EventEvent NotificationDisplay to go to the display configuration interface. Set the duration time of the pop-up video
and the pop-up message box. If you device support two outputs, please set the output of the pop-up video as needed. After that, click “Apply” to
save the settings.
11.6.4 Buzzer
Click StartSettingsAI/EventEvent NotificationBuzzer to go to the buzzer configuration interface. Set the delay time of the buzzer and then
click “Apply” to save the setting. You can click “Test” to test the buzzer.
11.6.5 Push Message
Click StartSettings AI/Event Event NotificationPush Message to go to the interface as shown below. Check “Enable” and then click “Apply”
to save the settings. If Push Server is online, it will push messages to the mobile clients.