User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record & Disk Management
- 8 Playback & Export
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Alarm Management
NVR User Manual
48
9.4.2 Warning Handling Settings
① Click StartSettingsAlarmExceptionWarning Handling Settings to go to the interface as shown below.
② Enable or disable “Push”, “Alarm-out”, “Buzzer”, “Pop-up Message Box” and “E-mail”. The exception handling settings are similar to that of the
sensor alarm (see 9.1 Sensor Alarm
for details).
③ Click “Apply” to save the settings.
9.5 Alarm Event Notification
9.5.1 Alarm-out
① Click StartSettingsAlarmEvent Notification to go to the following interface.
② Set the delay time and the schedule of each alarm-out. You can click “Edit Schedules” to edit the schedules (see 7.3.1 Add Schedule
for details).
③ Click “Apply” to save the settings. You can click “Test” to test the alarm output.
9.5.2 E-mail
Click StartSettingsAlarmEvent NotificationE-mail to go to the e-mail configuration interface. Set the e-mail address of the recipients. See
11.1.5 E-mail Configuration
for details.
9.5.3 Display
Click StartSettingsAlarmEvent NotificationDisplay to go to the display configuration interface. Set the duration time of the pop-up video