User Manual
Table Of Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 EZ Setup & Main Interface
- 4 Camera Management
- 5 Live View Introduction
- 6 PTZ
- 7 Record & Disk Management
- 8 Playback & Export
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Specifications
Account & Permission Management
NVR User Manual
54
② Check “Enable” and then choose “Enable Allow List” or “Enable Block List” (the PC client of which the IP address is in the allow list can access
NVR remotely while the PC client in the block list cannot).
③ Add IP/IP segment/MAC. Click “Add IP” or “Add MAC” button and then check “Enable” in the popup window (only if you check it can the IP/IP
segment/MAC you add be effective). Enter the IP/IP segment/MAC and then click “OK” button. In the above interface, click to edit IP/IP
segment/MAC, click to delete it. Click “Apply” to save the settings.
10.5 Preview On Logout
Click StartSettingsAccount and AuthoritySecurityPreview On Logout to go to the following interface.
Set a camera and then enable or disable the preview permission on logout as required. If a camera’s preview permission on logout is “ON”, you can
view the live image of the camera when the system is logged out, or the live image of the camera cannot be seen when logged out.
10.6 View Online User
Click StartSettingsAccount and AuthorityUser Status to view the online user information (you can view the online user name, login type, IP
address and login time; click to pop up a window showing the preview occupied channel number and playback occupied channel number).