Quick Start Guide O8FBMS1
Welcome Thank you for purchasing this network camera! This owner's manual is designed to be a reference tool for your system. Please read this manual carefully before operating the unit and retain it for future reference. Should you require any technical assistance, contact Speco Technologies Tech Support at 1-800-645-5516 Important Safeguards and Warning 1. Electrical safety All installation and operation here should conform to local electrical safety codes.
dampened with a small quantity of neutral detergent. Finally use the dry cloth to clean the device. Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may result in poor IR functionality and/or IR reflection. The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera. Warning This camera should be installed by qualified personnel only.
Plastic plug ×4 Rubber plug CD Drill template Junction box Overview 32 Overview 48 5 RS 8 9 1 + 432 ALA RM 1 2 3 4 5 6 7 1 Ethernet Connector * 2 Audio Input (MIC) 3 Audio Output (HP) 4 Alarm Input/Output 5 RS485 6 Power Connector * 7 Ground 8 Reset 9 Micro SD Card Slot
p ca y rit cu Se 1 RS485T+ RS485T- 48 5 RS G ro un d + 432 ALA RM 1--ALM-COM 2--ALM-OPEN 3--ALM-INA 4--ALM-GND * 1 It is recommended to install the security cap for outdoor installations. * 2 DC 12V power supply is not required if a PoE switch or injector is used to power the camera. ► Connecting Network Cable 1 2 3 ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through both elements. Then crimp the cable with RJ 45 connector.
3 Installation * Before you start, please make sure that the wall or ceiling is strong enough to withstand three times the weight of the camera. ① Mount the junction box to the wall or ceiling with screws. ② Route the cables and connect the relevant cables (Take cable going through mounting surface for example). Rubber plug ③ Fix the camera onto the junction box with screws.
④ Bracket adjustment. Before adjustment, preview the image of the camera on a monitor and then loosen the fixed screws to adjust the view angle of the camera. After that, tighten the fixed screws. Fixed screws Tilt: 90° Rotate: 360 ° Pan: 360° 4 Web Operation and Login IP Scanner can search for the device on the local network. ● Operation ① Make sure that the camera and the PC are connected to the same local network. The camera is set to DHCP by default.
O8FBMS1 5C:F2:07:24:68:B9 ③ In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer. You can also manually enter the IP address in the address bar of the web browser. The login interface is shown above. Default user name is admin and password is 1234. After logging in, follow directions to install applicable plugins.
