User Manual

O
O
I
I
P
P
C
C
2
2
1
1
T
T
7
7
B
B
O
O
w
w
n
n
e
e
r
r
’
’
s
s
M
M
a
a
n
n
u
u
a
a
l
l
Rev.1.2 (Oct. 2012)
18
4.2. Quick Installation Guide
1. Connect PC and OIPC21T7B to network.
1) Prepare a PC to run programs for the installation and video connection
(PC is needed to assign IP address to OIPC21T7B)
2) OIPC21T7B as shown in dotted line in Figure 4-1. The DC power is applied through DC adaptor.
Figure 4-1. Power and network connection
Install “IP installer and set IP parameters on OIPC21T7B
Insert the CD provided with product into the PC. Install WinPcap and IP Installer in sequence. Make sure
that IP Installer can’t run without WinPcap.
IP installer Ver. 3.0.1 or later is needed in the configuration of OIPC21T7B.
Follow the sequence below for setting the IP parameter
i) Run IP installer > Select Network Adaptor >OK
ii) Click ① in IP installer window.> Double click on ② > Fill in ④ > make a selection in ⑤ > Fill the
parameters in ⑥
iii) Click on ⑨ to apply the settings.
iv) You can connect to admin page by clicking on ⑩.
LAN switch
DC adaptor