User's Manual
Table Of Contents
- 1. General Description
- 2. Installation and Operation
- 3. Options
- 3.1 T01 Programmable Channel Spacing
- 3.2 T02 Programmable CTCSS encoder/decoder
- 3.3 T03 Programmable DCS/CTCSS encoder/decoder
- 3.4 T05 Balanced and Isolated VF plus E&M
- 3.5 T06 Simplex Changeover Relay
- 3.6 T08 VF Delay
- 3.7 T09 300Hz Upgrade HPF Filter
- 3.8 T10 Power Save Mode
- 3.9 T11 Combined Options
- 3.10 T12 External Reference Oscillator Input
- 3.11 T13 Local Speaker, Mic Socket and Front Panel Mute
- 3.12 T14 Local Channel Change
- 3.13 T16 1PPM Frequency Stability
- 3.14 U69 Extended Temperature Range Verification
- 3.15 T19/26 Line Interface Board.
- 3.16 T29 Balanced and Isolated VF plus E&M
- 3.17 T31 Network Adapter
- 3.18 T34 Ethernet option
- 3.19 T36 Option - TX Ref Oscillator input and Modulator
- 6. MX800 Base Station Fault Finding Procedure
- 7. Appendices
- 7.1 MX800 Interface Connections
- 7.2 CN2 DB9 Female Monitor Connector
- 7.3 CN3 DB25 Female Digital I/O Connector
- 7.4 MX800 Specifications
- 7.5 Channel Select DIP Switch Settings
- 7.6 MX800 Model Number Configuration Guide
- 7.7 MX800 System Applications
- 7.7.1 Conventional base station/repeater
- 7.7.2 Link transceiver
- 7.7.3 Data transceiver
- 7.7.4 Paging transmitter
- 7.7.5 Trunking Base Station
- 7.7.6 Systems base
- 7.7.7 Repeater with Morse ID
- 7.7.8 Simplex base station
- 7.7.9 Duplicated base station
- 7.7.10 Power Save base station
- 7.7.11 Tone key base station
- 7.7.12 Voting base station
- 7.7.13 Simulcast base station
- 8. Superseded Technical Information
- 9. Drawings
Technical Manual
3. Options
3.1 T01 Programmable Channel Spacing
3.1.1 Description
The MX800 receiver is available in five different channel spacing options.
For applications in systems that require both 12.5 kHz and 25 kHz channel
spacing option T01 allows channels to be programmed for either bandwidth.
Switchable IF filters in the receiver and automatic 12.5 kHz/25kHz gain
compensation in the audio paths make the change in bandwidth transparent to
the user.
This option has become Spectra’s standard build, therefore it is not necessary
to specify this option at order placement. Once the switchable IF bandwidth
receiver is fitted, the programmable channel spacing option must be selected
on the MXTOOLS Configuration screen (Hardware Settings tab) and each
channel is programmed as either 12.5 kHz/25kHz via the Channel Edit
screen.
Figure 3-1 MX800 T01 Option, Programable bandwidth fitted to RX module.
3.1.2 Installation
This option is factory fitted.
© SPECTRA ENGINEERING 2008 Revision 4.3.1B
21