User's Manual
Table Of Contents
- 1. General Description
- 2. Installation and Operation
- 3. Options
- 3.1 T01 Programmable Channel Spacing
- 3.2 T02 Programmable CTCSS encoder/decoder
- 3.3 T03 Programmable DCS/CTCSS encoder/decoder
- 3.4 T05 Balanced and Isolated VF plus E&M
- 3.5 T06 Simplex Changeover Relay
- 3.6 T08 VF Delay
- 3.7 T09 300Hz Upgrade HPF Filter
- 3.8 T10 Power Save Mode
- 3.9 T11 Combined Options
- 3.10 T12 External Reference Oscillator Input
- 3.11 T13 Local Speaker, Mic Socket and Front Panel Mute
- 3.12 T14 Local Channel Change
- 3.13 T16 1PPM Frequency Stability
- 3.14 U69 Extended Temperature Range Verification
- 3.15 T19/26 Line Interface Board.
- 3.16 T29 Balanced and Isolated VF plus E&M
- 3.17 T31 Network Adapter
- 3.18 T34 Ethernet option
- 3.19 T36 Option - TX Ref Oscillator input and Modulator
- 6. MX800 Base Station Fault Finding Procedure
- 7. Appendices
- 7.1 MX800 Interface Connections
- 7.2 CN2 DB9 Female Monitor Connector
- 7.3 CN3 DB25 Female Digital I/O Connector
- 7.4 MX800 Specifications
- 7.5 Channel Select DIP Switch Settings
- 7.6 MX800 Model Number Configuration Guide
- 7.7 MX800 System Applications
- 7.7.1 Conventional base station/repeater
- 7.7.2 Link transceiver
- 7.7.3 Data transceiver
- 7.7.4 Paging transmitter
- 7.7.5 Trunking Base Station
- 7.7.6 Systems base
- 7.7.7 Repeater with Morse ID
- 7.7.8 Simplex base station
- 7.7.9 Duplicated base station
- 7.7.10 Power Save base station
- 7.7.11 Tone key base station
- 7.7.12 Voting base station
- 7.7.13 Simulcast base station
- 8. Superseded Technical Information
- 9. Drawings
MX800 Transceiver Options
Pin No Function
1 600ohm balanced RX VF leg a
2 600ohm balanced RX VF leg b
3 600ohm balanced TX VF leg a
4 600ohm balanced TX VF leg b
5 M Lead common
6 M Lead normally open
7 E Lead leg a/M lead normally closed
8 E Lead leg b
Table 3-1 CN9 Connections
The RJ45 pins are numbered as shown below.
1 .................. 8
Figure 3-4 CN9 RJ45 Pin-out Detail (View from Rear of MX800)
Refer circuit diagram CS018-1
3.4.2 Installation
Components Required:
1. Option board T05. Qty-1
2. 3x5mm machine screw. Qty-3
3. 10way Female-to-Female connector assy. Qty-1
4. 16way Female-to-Female connector assy. Qty-1
5. Rear connector layout label. Qty-1
Test Equipment Required:
1. Communications Test Set
2. MX800 Radio Interface Box
© SPECTRA ENGINEERING 2008 Revision 4.3.1B
26