Technical Manual

1-4 ATLAS 4500 Multimode Station Technical Manual December 2016
Regulatory Information Section 1 - Introduction
1.3.2 FCC Part 15.21 Warning Statement
The grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. Such modifications could void
the user’s authority to operate the equipment.
1.3.3 FCC Part 15.105(b) Warning Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Do not operate the transmitter of a stationary radio (base station or marine radio)
when a person is within 14.89 feet (4.54 meters) of the antenna.
• The ATLAS 4500 has been approved to operate with the antenna types listed in
Table 1.1 with the maximum permissible gain and required antenna impedance
for each antenna type indicated. Antenna types not included in this list, having a
gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
Table 1.1 ATLAS 4500 Antennas
Antenna Manufacturer
and Model Number
Maximum Permissible
Antenna Gain
[dBd]
Required Impedance
[]
Telewave ANT395F6 6 50
Telewave ANT415F6
Telewave ANT440F6
Telewave ANT450F6
Telewave ANT500F6