Technical Manual
Table Of Contents
- ATLAS® 4500 Multimode Station
- Introduction
- Product Overview
- Installation and Configuration
- Alignment
- Maintenance
- Technical Support and Service
- UHF Circuit Descriptions
ATLAS 4500 Multimode Station Technical Manual December 2016 2-5
Hardware Description Section 2 - Product Overview
2.2.3 Rear Panel Connectors
Figure 2.4 shows the ATLAS 4500 rear panel and its connectors. Table 2.2 contains
descriptions of the connectors.
Figure 2.4 Rear Panel and Connectors
DB 25*
Connectors marked by * connect to the ATLAS 4500 logic card
N-Connector - Transmitter
Serial*
BNC Connector* - 10 MHz
Dual Ethernet*
Primary Audio*
Micro USB*
Power Switch
AC Power Connector
N-Connector - Receiver
BNC Connector* - 1 PPS
Wire/4 Wire E&M for Transmit and Receive
Secondary Audio* (not used)
4 Wire/4 Wire E&M for RX2
12 pins for Repeater I/O
13 pins for future use to be determined