Technical Manual
Table Of Contents
- ATLAS® 4500 Multimode Station
- Introduction
- Product Overview
- Installation and Configuration
- Alignment
- Maintenance
- Technical Support and Service
- 700/800 MHz Circuit Descriptions
1-2 ATLAS 4500 Multimode Station Technical Manual July 2016
Safety Information Section 1 - Introduction
• Technical Support and Service
1.2 Safety Information
1.2.1 Safety Precautions
These safety precautions, warnings and cautions advise personnel of specific
hazards that may be encountered during the procedures contained in this document.
Control measures are required to prevent injury to personnel, and damage to
equipment and the operating environment.
Before beginning the installation or any maintenance of this equipment, personnel
are to acquaint themselves with all risk assessments relevant to the work site and
the task. They must then comply with the control measures detailed in those risk
assessments.
References covering safety regulations, health hazards and hazardous substances
are detailed under the following WARNINGS section. These are referred to in the
tasks, when encountered.
Adequate precautions must be taken to ensure that other personnel do not activate
any equipment that has been switched off for maintenance.
1.2.2 Hazardous Substances
Before using any hazardous substance or material, the user must be conversant with
the safety precautions and first aid instructions:
• On the label of the container in which it was supplied.
• On the material Safety Data Sheet.
• In any local Safety Orders and Regulations.