Product Manual

6. If you chose Setup at Any Location (see also diagram below):

• Set up the instrument at any convenient location from

which you have a good view of the two reference points.

• Select the first reference point from the plan ([1]).

Have a target placed over this point. Aim the

instrument at this point and shoot it ([2])

• Repeat the first step for the second reference point

used ([3] and [4]). You then get screen [5] on which

the instrument position is reported to have been

determined. Ensure that the calculated position of the

instrument makes sense compared to the plan.

• Tap Finish to complete station setup. If you want to

store the point where the instrument is located, first

enable the Store Instrument Location option, tap Next,

name the point and tap Finish.

NOTE: If elevation is measured, and because the

instrument height cannot be entered in that case, be

aware that the measured height will be that of the

instrument itself, not that of the point on the ground.

If you know exactly the height of the tripod used, and

after storing the position of the instrument, you can

edit its Z coordinate to make it a point on the ground.

[1] [3]

[2] [4]

[5]