- Spectra User Guide Lithium Battery 10000

Chapter 7. Troubleshooting

Drive alert displayed

Touch the drive button showing the alert (Drive 3 in Figure 7-6) to view the detailed

alert information on the first Drive Info screen.

The Drive Info screen describes the cause of the alert:

Tape Life The tape being used may be at the end of its usable life. If possible, replace

the tape and retry the store or restore operation.

Tape Drive Error Rates The alert may be caused by excessive drive error rates. Clean the

drive using a Sony SDX-TCL cleaning cartridge, as described in Cleaning Drives on

page 86. Then retry the store or restore operation

System fault displayed

Touch the System Fault button for information on the cause of the error. If an error

code is given, find the error code in Spectra Logic’s online Sense Code Lookup at

http://www.spectralogic.com/support/senselookup/index.cfm/fuseaction/

DisplayIndex. Use the suggestion given there to clear the fault.

After clearing the fault, power cycle the library, then verify that the unit comes to a

Unit Ready state. If the fault still does not clear, contact Spectra Logic Technical

Support for assistance.

Figure 7-6 Drive alert displayed.