Product Manual

English
7
• Choose the desired source of corrections, and then touch
the horizontal right arrow in the lower-right corner of the
screen.
1. If you chose SBAS: The message Setting up application
will appear briefly, followed by the SKYPLOT view (see
below).
2. If you chose NTRIP: The first time you want to make
an NTRIP connection, there is no predefined
connection profile available. Touch the “+” symbol in
the lower-left corner of the screen and then enter the
parameters of your NTRIP provider:
Host Name or IP Address
Friendly Name (max 20 chars)
Port Number
Touch the Get Source Table button to list the mount
points available from this provider and select one. If
you remember the name of the mount point you want
to use, you don’t need to acquire the source table: Just
touch the Enter Mount Point button and type in the name
of the desired mount point.
Then enter your NTRIP credentials (User Name and
Password).
Touch Connect at the bottom of the screen. At this
point, SPace will initiate a network connection to allow
the MobileMapper 300 to receive corrections from the
chosen NTRIP provider. The message “Please Wait” will
appear, followed by another message “Setting up
application”. Then the SKYPLOT view will be displayed
(see below).
3. If you chose DIP: The first time you want to make a DIP
connection, there is no predefined connection profile
available. Touch the “+” symbol in the lower-left
corner of the screen and then enter the parameters of
your DIP provider:
Host Name or IP Address
Friendly Name (max 20 chars)
Port Number
Touch Connect in the lower part of the screen. At this
point, SPace will initiate a network connection to allow
the MobileMapper 300 to receive corrections from the
chosen static IP address. The message “Please Wait”
will appear, followed by another message “Setting up