Product Manual

English
11
SPace Settings
: Touch this icon (see [7]) to read or change SPace’s
current settings:
• Autostart application at boot: Can be set to ON or OFF. To
change this setting, simply touch the line or push the
button at the end of the line to the right (ON) or to the left
(OFF).
Setting this feature to ON means SPace will be started
automatically next time you power on your mobile device.
This way, provided Bluetooth and possibly network
connections can be restored automatically (see NOTE
above), you don’t have anything else to do at power up, but
start your GIS job as soon as the system is ready to
operate.
• Receiver: Bluetooth identifier of the currently connected
MobileMapper 300. If you touch this line, you start a
Bluetooth scan, to search for all nearby Bluetooth
receivers.
• Correction Information: Source of corrections currently
used. If you touch this line, you may change the type of
connection through which corrections enter the
MobileMapper 300 (SBAS, NTRIP or DIP; see above). By
touching the “+” symbol after selecting “NTRIP” or
“DIP”, you may add a new NTRIP or DIP provider
respectively.
• Antenna Height (in meters): Currently used value of antenna
height (rod length). You may touch this line to change the
antenna height.
• Help: Touch this line to open the Help page. Use the Back
key on the device to close the Help page.
• About: Touch this line to read the installed SPace software
version.