Product Manual

English
17
Auto-Test at Start-up Auto-test is performed during the receiver start-up sequence
to check internal communication ports, including Bluetooth.
Should a problem be detected during the auto-test, the
Power/Charging LED will turn solid red -instead of the normal
solid green- at the end of the start-up sequence. In that case,
you should reset the receiver as explained in this manual (see
above). If the error still persists after a reset, please contact
Technical Support.
Installing a
Firmware Upgrade
In the future, Spectra Precision may provide a maintenance
file (a *.bin file) should the MobileMapper 300 firmware
need to be upgraded.
In that case, please use Spectra Precision’s Spectra Precision
loader software utility to install the firmware upgrade.
This utility can be downloaded from:
http://www.spectraprecision.com/products/
gis-mobile-mapping/mobilemapper-300/
(Then click on the Support tab)
Spectra Precision loader should be installed on a computer
fitted with a USB or RS232 port, or having Bluetooth
capability.
Follow the instructions below to upgrade your MobileMapper
300:
• Set up MobileMapper 300 according to one of the
diagrams below (see also Optional Accessories on page 2
for the serial setup).
1) Bluetooth
2) Serial Cable
Universal AC/DC
adapter cable (to power line), or
vehicle power cable (to external battery)
Bluetooth
Power cable
extension
Universal AC/DC
adapter cable (to power line), or
vehicle power cable (to external battery)
Cable kit P/N 91865-00
DB9
USB