Product Manual

English
21
Memo • [1]: Power/Fast charging pushbutton. Hold this button
depressed for about 2 seconds to power on the
MobileMapper 300. Hold it depressed for another 2
seconds to turn it off.
While the batteries are being charged in standard mode, a
brief press on this button will cause the MobileMapper
300 to switch to fast charging mode.
Whether the MobileMapper 300 is on or off, holding this
button depressed for 12 seconds will cause the
MobileMapper 300 to start a reset sequence, which lasts
typically 25 seconds (no user data lost during a reset).
• [2]: Power/Charging LED. At power-up, it turns
successively and repeatedly red and green (over about 20
seconds) denoting start-up in progress. Once start-up is
complete, the LED turns solid green, unless the remaining
charge in the batteries is less than 20%, in which case the
LED will be blinking green.
When charging the batteries, the Power/Charging LED
flashes red at a slow rate (standard charging) or at a fast
rate (fast charging).
• [3]: Bluetooth LED: When you turn on the MobileMapper
300, the Bluetooth LED stays off throughout the start-up
sequence. Then, it produces blue flashes every 1 second
or so, until a Bluetooth connection is established between
the MobileMapper 300 and the mobile device. The LED
then turns solid blue and will stay in that state as long as
the Bluetooth connection is kept active.
[1] [2] [3]