Product Manual

English
4
5. Wait a few hours until the batteries are fully charged. End
of charging is denoted when the Power/Charging LED goes
out.
6. Disconnect the AC/DC adapter from the MobileMapper
300. Put the cap back in place to protect the Power/Data
connector during field operations.
NOTE: The MobileMapper 300 may be left on the AC/DC
adapter indefinitely without damage.
Getting Started 1. Thread the MobileMapper 300 onto a range pole.
2. Attach the mobile device bracket to the pole.
3. Attach the mobile device to the bracket.
4. Turn on the MobileMapper 300 by holding the Power
button depressed for about 2 seconds.
Check the status of the Power/Charging LED, which
should blink red and green slowly while the MobileMapper
300 is being started (this takes about 20 seconds).
After the MobileMapper 300 has started, the Power/
Charging LED turns solid green meaning the
MobileMapper 300 is now functioning and ready for use.
At the same time, the Bluetooth LED will start flashing
blue at a rate of approximately 1 second, meaning that the
MobileMapper 300 is ready to accept a Bluetooth
connection.
5. Turn on the mobile device.
6. Run SPace to first establish a Bluetooth connection with
MobileMapper 300, and then to choose and set the
transmission channel (i.e. SBAS, NTRIP or DIP) through
which corrections will enter the MobileMapper 300. (see
instructions in Setting MobileMapper 300 to Receive
Corrections on page 6).
7. Using SPace, check that MobileMapper 300 delivers
accurate positions.
8. Run your GIS application. SPace will continue to run in
the background.
Reading the
Battery Status
At any time while using the MobileMapper 300, you can
monitor the remaining charge in the two built-in batteries by
reading the status of the Power/Charging LED:
• Solid green: remaining charge is greater than 20%.
• Blinking green: remaining charge is less than 20%.