Product Manual

Entering Grade – changing the grade value in Step + Go or Digit Select mode.

Press and release the M (Menu) button; Grade Edit will be highlighted.

Press/release button E  The grade value will be shown.

Press/release button M  escape/return to the standard display.

Note: when ‘Step + Go Mode’ is selected, the grade can be changed just by pressing the plus

[17] and minus [18] arrow. One arrow button press opens the grade edit menu. To change

grade see chapter ‘Step + Go Mode’

Step + Go Mode:

Press and hold (+/-) buttons for changing the grade value after the comma.

Press/release button 2/5  change the sign of the grade value.

Press and hold Plus (+) and Minus (-) buttons simultaneously starts Quick change mode

where the grade value will be set to 0% and then starts changing in front of the comma in 1%

increments.

Note: When the grade value for the axis reaches its highest amount, the grade value switches

to the lowest value for that axis. For example, the value switches from +40% to -12%.

The laser will self-level to the required grade position a few seconds after the grade change

buttons have been released.

Note: The bubble symbol at the laser’s and remote’s LCD will flash until the laser has been

self-leveled to the requested grade position.

Digit Select Mode (Default):

A cursor at the sign of the grade value is flashing.

Press and hold the ESC button quick set to 0%.

Press/release Plus (+) and Minus (-) buttons  change the sign of the grade value.

Pressing and releasing right or left button moves the cursor to the right/left.

Press and release Plus (+) and Minus (-) buttons to change the selected digit.

The laser will self-level to the required grade position after confirming the grade change with E

(Enter) button.

Grade Entering can be exited any time by pressing and releasing M button.