Product Manual

Line Scan - For a faster second day setup, line scan enables complete
automatically movement of the laser beam to the left and right limits.
Press and release the M button at the standard display and select
Line Scan using the (+)/(-) and left/right buttons.
Press/release button M  escape/return to the standard display.
Pressing and releasing E button activates the Line Scan mode while the laser beam moves
to the right/left limits of the horizontal axis (short beep) and stops at the center position.
When the beam crosses the target press the ESC button to stop the automatic beam
movement.
Corrections for centering the beam at the target can be done using the left/right buttons.
Line Set/Check - Moves the laser beam vertically plumb to its maximum limit for setting
line in a first day setup without a SF803.
Press and release the M button at the standard display and select Line Set/Check using
the (+)/(-) and left/right buttons.
Press/release ESC button  escape/return to the standard display.
Pressing and releasing E button starts the Line Set/Check mode.
The beam moves to the 0% position while the flashing Line Set/Check symbol appears.
The Line Set/Check symbol stops flashing when the beam starts moving vertical
automatically up to 45°/ 100%.
Using the + or - button at the RC803 remote control or at the laser stops the automatic
upwards beam movement. Adjust the beam using Left/Right buttons until the beam is
centered at the line stake. After aligning the beam to the required direction position,
pressing and releasing the E button starts the beam plumb down movement to the
previous dialed in grade value.
Line Set/Check can be exited any time by pressing and releasing ESC button.
25