Owner manual

English

Choose the installation file (an “exe” file) corresponding

to the model of data collector you are using.

•

Con

nect the data collector to your office computer using

the USB data cable provided. For a ProMark 1x0 or

ProMark 2x0, place the receiver on its docking station and

connect the docking station to the computer through the

USB cable.

• Turn on the data collector.

• On your computer, run the “exe” file you have just

downloaded. This starts the FAST Survey Setup Wizard.

• Click Next>.

• Check on the I accept the terms in the License Agreement

option and then click Install.

• At the end of this phase, a message appears asking you to

check the data collector screen to see if additional steps

are needed to complete the installation.

• Click OK, then Finish to complete installation on computer

side.

• On the data collector, the installation phase has

automatically started. For a ProMark 1x0 or ProMark 220,

a message first appears asking you to choose the location

where to install FAST Survey (the default “Device” option

is recommended), then tap on Install to continue.

When the progress bar disappears from the screen, this

means installation is complete. The FAST Survey icon can

then be seen on the screen.

For a ProMark 1x0 or 2x0, a message indicates that

installation has been successful. Tap OK to go back to the

screen where the FAST Survey command line and icon are

now visible.