Owner manual

English

• Position Rate: 1- or 2-Hz position output rate.

• Store Vectors in Raw Data: With this option enabled, FAST

Survey will save the computed vectors into the job (into

the RW5 file)

• Base Receiver Type: You may specify the manufacturer of

the base providing your rover with corrections. This will

ease the process through which the rover can decode

these corrections. If you have no idea which receiver

model is used at the base, select AUTOMATIC and the rover

will automatically find out the manufacturer of the base

receiver.

• Use GLONASS: Remember that activating the Use GLONASS

option in ProMark 220 will be effective only if you have

previously set the Tracking mode parameter in GNSS

Toolbox to “GPS L1+GLONASS L1” or “GPS/GLONASS

L1/L2”. As for the Use SBAS and Use QZSS options, only

the last setting made is effective, whether you do it from

GNSS Toolbox or from FAST Survey.

• Send file after config: You may have a number of additional

commands executed (proprietary commands of the

“$PASH” type) when later you tap on to configure the

receiver. These commands must have been saved to a text

file, for example to a file created using Equip > GPS Utility

> Send command. To select the file you want the receiver to

execute when being configured, tap on the blue button

and highlight the corresponding file name.

•

NMEA Output Port: You may ask the rover to output one or

more NMEA messages (GGA, GLL, RMC, VTG, GSV, GSA,

ZDA, GST) on the specified output port. Once you have

defined the output port (common to all NMEA

messages), tap on the Configure button and then, for

each desired NMEA message, select its output rate (in

Hertz or seconds).

• Ambiguity Fixing (see table below).

• Use QZSS: Enables/disables the use of the QZSS (Quasi-

Zenith Satellite System) constellation covering Japan and

the Far East.

Choice Definition

Float

Choose this option if you only need decimeter accuracy (position

status will never go to “Fixed”).

95.0 95% confidence level

99.0 99% confidence level (default and recommended setting)

99.9

99.9% confidence level