Instruction Manual

21
The internal modem should be configured first:
• Click on the Connections menu and then on the Bluetooth/
Modem sub-menu.
• Set the following parameters in the Internal Modem/Device
Settings pane:
– Power: Select “On”. Then choose whether the modem
should be turned on automatically or manually:
Automatic: The modem will be switched on or off
automatically when the rover is respectively turned on
or off.
Manual: The modem will be powered up only by going
through the Connections > Bluetooth/Modem page,
setting the modem to “Power On” and clicking on the
Configure button (or using the $PASHS,MDM,ON
command).
– Automatic Connection: Check this option.
– Pin: 4- to 8-character pin code of the SIM card used in
the modem for GPRS operation.
– 2G Only: Recommended to save power.
• Set the following parameters in the Internal Modem/GPRS
Mode Settings pane (the mobile communication provider
you are using should be able to give you all this
information):
– Internet Protocol: Choose the Internet protocol (TCP or
UDP) allowing the modem to perform an Internet
connection.
– Access Point: Enter the URL of the mobile
communication provider.
– Access Point Login: Enter the login of the mobile
communication provider.
– Password: Enter the password of the mobile
communication provider.
• Click on the Configure button.
• Now please follow all the steps described in section
General Parameters on page 16 and then proceed with the
steps below.
• Still on the Rover Setup page, in the Network pane, set the
following parameters:
– Connection: Choose “Modem Direct IP - Port E”. As a
result, new fields appear in this pane that you should
set as instructed below: